Cutek Green Weather and Temperature Application Instructions.
Wood that is to be coated with Cutek Green should be clean and dry and ideally with a residual moisture content of no higher than 17%. Do not apply Cutek Green to exterior wood if its likely to rain within 24 hours of application.
Cold temperatures may increase the viscosity of Cutek Green, tending to slow down the rate of diffusion. Storing containers in a warm place immediately prior to application will help alleviate this problem. Because Cutek Green dries by diffusing into the wood substrate, application of a second coat of Cutek Green too quickly after the first coat in cold weather will significantly delay the penetration and drying of the finished coating. If this inadvertently occurs, remove the access Cutek Green from the surface with a rag will promote faster drying. Alternatively, the application of the second coat of Cutek Green may be delayed for up to three months in cold weather, with no detrimental effect to the effectiveness of the original coating.
Cutek Green can be purchased at www.myocstore.com





